Ok, so after a week of googling, youtubing etc, I finally got my C2000T bridged to a Linkysys WRT54GL and it is working. I updated the Linksys to DD-WRT so I can use VPN on my wireless devices. It took several pages to get nuggets from each (the best on this forum that provided the final solution). I went cheap with the router in case I bricked it. Got pretty good about resetting the C2000T a hundred times ;)
Now I find out that I need a 2nd router because the WRT is in PPPoE mode to connect to the C2000T DSL. I cannot set it to PPTP
Has anyone done this and have instructions or a link? I can usually figure out and perform tasks, but I'm no network expert.
I want to do this wired. In the above setup, I didn't change any ethernet adapter settings in windows
Connected WAN to WAN Computer connected ethernet to Linksys
C2000T 192.168.0.1 Wireless disabled on C2000T DCHP disabled, NAT disabled.
Linkysys 192.169.1.100 DCHP enabled. wireless enabled
I cannot get to 192.168.0.1 in the browser which I gather is correct as it is bridged.
↧